U BESPAART 10% BIJ HET KOPEN VAN PALLETS

GROTE BESTELLINGEN KUNNEN  GELEVERD WORDEN IN 4 TOT 6 WEKEN.

1 palet=64STK

Product Description
Cement based, flexible adhesive mortar with reduced slip property used to adhere products
such as ceramics, porcelain, granite, marble, natural stone, glass mosaic and pressed brick
with extended working time. (C2=cement based adhesive with additional properties,
T =reduced slip, E=extended open waiting time S1 =flexible)

Areas of Usage
• lndoor and outdoor, on terrace and balconies,
• in places such as a swimming pool that are constantly exposed to water,
• in the application of coating materials of size 40x40 cm and larger,
• Wherethere is intense pedestrian and load traffic or where heat changes are high,
• Far adhering materials such as granite ceramic, marble and natural granite,
• Where there is a lot of heat difference,
• Far applications on gypsum plaster, gypsum board, aerated concrete and exposed concrete,
• it gives excellent results in ceramic and granite bonding works on the exterior facades.
• Far adhering natural stone, BTB, glass mosaics,
• in wet volumes such as swimming pool, water depot, bath, ete,
• On floors with floor heating, in heated pools, in thermal pools, in swimming pools where water is
not drained in winter, in walls and floor coverings in cold storages.

Features and Benefits
• High adhesion.
• it does not slip in vertical applications.
• Easy to prepare and apply.
• it is resistant to water, nipple and frost.
• Processing time is long.
• it does not slip in vertical applications.

Application lnstructions
Surface quality: The surfaces should be clean, smooth, sound and at the same time level, weak
parts should be removed and damaged surfaces should be repaired with TEKNOREP. There should
be no grease or mortar rust on the surface.
Surface Preparation: lf applied on marble, ceramics and pellets, the surfaces should be roughened.
Concrete floor should be damp but there should be no water accumulation.
Mixing: 6,0 - 7,2 it clean, clear water received from normal ambient temperature into a clean
container which is free from all kinds of materials which prevent adhesion. Teknofay flex pro in 25
kg bag as powder is poured into a container filled with water. The product is mixed with a low
speed mixer with ceramic mixer tip until a homogeneous mixture without lumps is obtained. The
mortar obtained at the end of the process should be rested far 5-1 O minutes and mixed
again until it becomes homogenous far 1-2 minutes.

Application Notes / Restrictions
• The product may be irritating to the skin. Work clothes, protective gloves, masks and glasses
must be used.
• A protective cream can alsa be applied before starting. in case of mortar contact with eyes, eyes
should be washed immediately with warm water and consult a doctor.
• it must be protected under ambient conditions below (+) 5°C, the product should be covered
with nylon or exposed to freezing by spreading heat insulation plates.
• it must be protected at temperatures above (+) 35°C, covered with nylon or heat insulation
plates should be laid out to prevent the product from being exposed to sudden water loss.
• At least 24 hours after the application ofTeknofay flex pro, the joint filling should be started.
• Do not add foreign matter.
• it must be protected after application against adverse weather conditions such as direct
sunlight, high air temperature (above + 35°C}, rain and frost. Teknofay flex pro should be cleaned
with water without getting hard and hard. lmmediately after application, hands and face should
be washed thoroughlywith soap and warm water.
• lmmediately after applying the equipment, the mortar should be washed with water without
hardening.
• Combined methods should be preferred in applications where there is intense pedestrian and
load traffic orwhere heat changes are high.

Storage Conditions
it should be stored in original unopened package, in cool and dry environment, protected from
freezing.